| Peer-Reviewed

Developing of New Structure of Flat Plate Solar Water Heater and Method for Calculation and Design

Received: 1 May 2016     Accepted: 18 June 2016     Published: 6 July 2016
Views:       Downloads:
Abstract

Single pane glazed flat solar heaters found rather wide application for domestic hot water supply. However, the practice of use shows some discrepancy between estimated and observed data: in one case the temperature of hot water does not conform to the expected pattern, in other case doubts arise about correctness of their sizes, in some cases the quantity of heated water is not enough, etc. Because of such divergence of opinions, it is becoming necessary to think about correctness of existing methods of sizing and designing of flat plate solar water heaters. This article attempts to develop a new structure and improved method for calculation and design of flat plate solar water heaters. Analysis proved relatively higher energy and cost effectiveness of the new structure of flat plate solar water heater.

Published in International Journal of Energy and Power Engineering (Volume 5, Issue 4)
DOI 10.11648/j.ijepe.20160504.11
Page(s) 141-147
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2016. Published by Science Publishing Group

Keywords

Flat, Solar, Heater, Tunnel, Similarity, Criterion, Nusselt, Prandtl

References
[1] H. P. Garg Treatise on Solar Energy, Volume 1: Fundamentals of Solar Energy/New York, Toronto, 1982, John Villy and Sons Ltd, p. 587, ISBN 10180 X.
[2] “Constructive climatology,” Constructions Codes of Armenia II-7.01-2011, Yerevan, 2013, 54 pages, Published in Armenian.
[3] V. N. Bogoslovskij, “Thermal physics of constructions,” Publ. house “High School”, Moscow, 1982, 415 pages, Published in Russian.
[4] Z. A. Melikyan, “Heating–Cooling of Buildings. Efficiency of Conventional and Renewable Technologies,” LAP Lambert Academic Publishing, Germany, 2012, 344 pages ISBN- 978-3-8443-1939-2.
[5] Hans Dieter Baehr, Karl Stephan, “Heat and Mass Transfer,” Third revised edition, Springer-Verlag Berlin Heidelberg, 2011, 762 pages, ISBN 978-3-642-20020-5.
[6] M. A. Mikheev, I. M. Mikheeva, “Heat transfer fundamentals,” Second edition, Publ. House: “Energia”, Moscow, 1977, 344 pages, Published in Russian.
[7] “Air Properties-Temperature, density, specific heat, thermal conductivity, expansion coefficient, kinematic viscosity and Prandtl's number” http://www.engineeringtoolbox.com/air- properties-d_156.html
[8] Zohrab Melikyan, Vahan Nranyan. Solar Water Heaters: Cylindrical Shell and Tube Type. Encyclopedia of Energy Engineering and Technology, Second Edition. Taylor and Francis: New York, Published online: 17 Jun 2015; 1760-1767 pp.
[9] Khaled Zelzouli, Amenallah Guizani, Ramzi Sebai, Chakib Kerkeni. Solar Thermal Systems Performances versus Flat Plate Solar Collectors Connected in Series, Scientific Research, Engineering, 2012, 4, 881-893 http://dx.doi.org/10.4236 /eng.2012.412112. Published Online December 2012.
[10] “Sun Maxx Titan Power Plus-SU 2 Solar Flat Plate Collectors” http://www.solarthermaltraining.org/sunmaxx-m2-solar-flat-plate-collectors.php
[11] Zohrab Melikyan. Energy Efficiency and Cost Effectiveness of Solar Water Heaters. International Journal of Energy and Power Engineering. Vol. 4, No. 3, 2015, pp. 184-188. doi: 10.11648/j.ijepe.20150403.17.
Cite This Article
  • APA Style

    Zohrab Melikyan, Siranush Egnatosyan. (2016). Developing of New Structure of Flat Plate Solar Water Heater and Method for Calculation and Design. International Journal of Energy and Power Engineering, 5(4), 141-147. https://doi.org/10.11648/j.ijepe.20160504.11

    Copy | Download

    ACS Style

    Zohrab Melikyan; Siranush Egnatosyan. Developing of New Structure of Flat Plate Solar Water Heater and Method for Calculation and Design. Int. J. Energy Power Eng. 2016, 5(4), 141-147. doi: 10.11648/j.ijepe.20160504.11

    Copy | Download

    AMA Style

    Zohrab Melikyan, Siranush Egnatosyan. Developing of New Structure of Flat Plate Solar Water Heater and Method for Calculation and Design. Int J Energy Power Eng. 2016;5(4):141-147. doi: 10.11648/j.ijepe.20160504.11

    Copy | Download

  • @article{10.11648/j.ijepe.20160504.11,
      author = {Zohrab Melikyan and Siranush Egnatosyan},
      title = {Developing of New Structure of Flat Plate Solar Water Heater and Method for Calculation and Design},
      journal = {International Journal of Energy and Power Engineering},
      volume = {5},
      number = {4},
      pages = {141-147},
      doi = {10.11648/j.ijepe.20160504.11},
      url = {https://doi.org/10.11648/j.ijepe.20160504.11},
      eprint = {https://article.sciencepublishinggroup.com/pdf/10.11648.j.ijepe.20160504.11},
      abstract = {Single pane glazed flat solar heaters found rather wide application for domestic hot water supply. However, the practice of use shows some discrepancy between estimated and observed data: in one case the temperature of hot water does not conform to the expected pattern, in other case doubts arise about correctness of their sizes, in some cases the quantity of heated water is not enough, etc. Because of such divergence of opinions, it is becoming necessary to think about correctness of existing methods of sizing and designing of flat plate solar water heaters. This article attempts to develop a new structure and improved method for calculation and design of flat plate solar water heaters. Analysis proved relatively higher energy and cost effectiveness of the new structure of flat plate solar water heater.},
     year = {2016}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Developing of New Structure of Flat Plate Solar Water Heater and Method for Calculation and Design
    AU  - Zohrab Melikyan
    AU  - Siranush Egnatosyan
    Y1  - 2016/07/06
    PY  - 2016
    N1  - https://doi.org/10.11648/j.ijepe.20160504.11
    DO  - 10.11648/j.ijepe.20160504.11
    T2  - International Journal of Energy and Power Engineering
    JF  - International Journal of Energy and Power Engineering
    JO  - International Journal of Energy and Power Engineering
    SP  - 141
    EP  - 147
    PB  - Science Publishing Group
    SN  - 2326-960X
    UR  - https://doi.org/10.11648/j.ijepe.20160504.11
    AB  - Single pane glazed flat solar heaters found rather wide application for domestic hot water supply. However, the practice of use shows some discrepancy between estimated and observed data: in one case the temperature of hot water does not conform to the expected pattern, in other case doubts arise about correctness of their sizes, in some cases the quantity of heated water is not enough, etc. Because of such divergence of opinions, it is becoming necessary to think about correctness of existing methods of sizing and designing of flat plate solar water heaters. This article attempts to develop a new structure and improved method for calculation and design of flat plate solar water heaters. Analysis proved relatively higher energy and cost effectiveness of the new structure of flat plate solar water heater.
    VL  - 5
    IS  - 4
    ER  - 

    Copy | Download

Author Information
  • National University of Architecture and Construction of Armenia, HVAC and Energy, Yerevan, Armenia

  • National University of Architecture and Construction of Armenia, HVAC and Energy, Yerevan, Armenia

  • Sections