American Journal of Electrical Power and Energy Systems

| Peer-Reviewed |

Transformer Wireless Monitoring System Using Arduino/XBEE

Received: 28 November 2018    Accepted: 21 December 2018    Published: 31 January 2019
Views:       Downloads:

Share This Article

Abstract

Distribution transformers are generally provided with advanced control measures that ensure their operation and safety at a high reliability because their failure usually leads to long power outage, increase maintenance cost and unreliable provision of electricity to customers. Despite the protection measures that accompany a distribution transformer, there is still a need to provide extra remote monitoring systems to increase the reliability of operation and the confidence of instantaneous fault reporting. This paper deals with the design and construction of automatic monitoring system for power transformer parameters. An Arduino board coupled with XBEE module were programmed to enable the monitoring of voltage, current and temperature on a typical power transformer. The system was implemented and tested successfully. Results showed that the voltage versus temperature as well as current versus voltage characteristic obtained, were closed to datasheet specifications and therefore confirming the reliability of the proposed design. This system is therefore recommended as an additional protection that should be added to Power Transformers.

DOI 10.11648/j.epes.20190801.11
Published in American Journal of Electrical Power and Energy Systems (Volume 8, Issue 1, January 2019)
Page(s) 1-10
Creative Commons

This is an Open Access article, distributed under the terms of the Creative Commons Attribution 4.0 International License (http://creativecommons.org/licenses/by/4.0/), which permits unrestricted use, distribution and reproduction in any medium or format, provided the original work is properly cited.

Copyright

Copyright © The Author(s), 2024. Published by Science Publishing Group

Keywords

Transformer, Arduino Board, XBEE Module, Wireless Monitoring, Transformer Fault Reporting

References
[1] M. Arshad, S. M. Islam, and A. Khaliq, “Power transformer asset management,” Power Syst. Technol. 2004. PowerCon 2004. 2004 Int. Conf., vol. 2, no. November, p. 1395–1398 Vol.2, 2004.
[2] Abb-Group, “Transformer Handbook,” Quality, p. 213, 2004.
[3] D. Arvind, S. Khushdeep, K. Deepak, and Nanak, “Condition monitoring of power transformer : a review,” in 2008 IEEE/PES Transmission and Distribution Conference and Exposition, 2008, pp. 2–7.
[4] T. Suwanasri, E. Chaidee, and C. Adsoongnoen, “Failure statistics and power transformer condition evaluation by dissolved gas analysis technique,” in Proceedings of 2008 International Conference on Condition Monitoring and Diagnosis, CMD 2008, 2007, pp. 492–496.
[5] R. Murugan and R. Ramasamy, “Failure analysis of power transformer for effective maintenance planning lectric utilities,” Eng. Fail. Anal., vol. 55, pp. 182–192, 2015.
[6] A. C. Nishant, “Failure Analysis of a Power Transformer Using Dissolved Gas Analysis – a Case Study,” Int. J. Res. Eng. Technol., vol. 3, no. 5, pp. 300–303, 2014.
[7] A. Rafa, S. Mahmod, N. Mariun, W. Z. W. Hassan, and N. F. Mailah, “Protection of power transformer using microcontroller-based relay,” Student Conf. Res. Dev., pp. 224–227, 2002.
[8] D. M. Mehta, P. Kundu, A. Chowdhury, and V. K. Lakhiani, “DGA diagnostics save transformers - Case studies,” in 2015 International Conference on Condition Assessment Techniques in Electrical Systems, CATCON 2015 - Proceedings, 2016, pp. 116–120.
[9] C. H. Einvall and J. R. Linders, “A Three-phase Differential Relay for Transformer Protection,” IEEE Trans. Power Appar. Syst., vol. 94, no. 6, pp. 1971–1980, 1975.
[10] H. Dashti and M. Sanaye-Pasand, “Power transformer protection using a multiregion adaptive differential relay,” IEEE Trans. Power Deliv., vol. 29, no. 2, pp. 777–785, 2014.
[11] National Communications System, “Supervisory Control and Data Acquisition (SCADA) Systems,” Tech. Inf. Bull. 04-1, no. October, p. 76, 2004.
[12] D. Peharda, I. Ivanković, and N. Jaman, “Using Data from SCADA for Centralized Transformer Monitoring Applications,” in Procedia Engineering, 2017, vol. 202, pp. 65–75.
[13] V. M. Igure, S. A. Laughter, and R. D. Williams, “Security issues in SCADA networks,” Comput. Secur., vol. 25, no. 7, pp. 498–506, 2006.
[14] X. Liu, H. Chen, M. Wang, and S. Chen, “An XBee-Pro based energy monitoring system,” Telecommun. Networks Appl. Conf. (ATNAC), 2012 Australas., pp. 1–6, 2012.
[15] V. Boonsawat, “XBee wireless sensor networks for temperature monitoring,” Second Conf. …, p. 6, 2010.
[16] N. S. A. Zulkifli, F. K. Che Harun, and N. S. Azahar, “XBee wireless sensor networks for Heart Rate Monitoring in sport training,” in 2012 International Conference on Biomedical Engineering, ICoBE 2012, 2012, pp. 441–444.
[17] T. H. Y. Ling, L. J. Wong, J. E. H. Tan, and C. K. Lee, “XBee Wireless Blood Pressure Monitoring System with Microsoft Visual Studio Computer Interfacing,” in Proceedings - International Conference on Intelligent Systems, Modelling and Simulation, ISMS, 2015, vol. 2015–Octob, pp. 5–9.
[18] A. H. Kioumars and L. Tang, “ATmega and XBee-based wireless sensing,” in ICARA 2011 - Proceedings of the 5th International Conference on Automation, Robotics and Applications, 2011, pp. 351–356.
Author Information
  • Department of Electrical and Electronics Engineering, Faculty of Engineering, Accra Technical University, Accra, Ghana

  • Department of Electrical and Electronics Engineering, Accra Institute of Technology, Accra, Ghana

  • Department of Electrical and Electronics Engineering, Faculty of Engineering, Takoradi Technical University, Sekondi-Takoradi, Ghana

  • Electricity Company of Ghana, Accra, Ghana

  • Department of Computer Science, Faculty of Applied Sciences, Accra Technical University, Accra, Ghana

Cite This Article
  • APA Style

    Amevi Acakpovi, Chiedozie Odazie, Issah Babatunde Majeed, George Eduful, Nana Yaw Asabere. (2019). Transformer Wireless Monitoring System Using Arduino/XBEE. American Journal of Electrical Power and Energy Systems, 8(1), 1-10. https://doi.org/10.11648/j.epes.20190801.11

    Copy | Download

    ACS Style

    Amevi Acakpovi; Chiedozie Odazie; Issah Babatunde Majeed; George Eduful; Nana Yaw Asabere. Transformer Wireless Monitoring System Using Arduino/XBEE. Am. J. Electr. Power Energy Syst. 2019, 8(1), 1-10. doi: 10.11648/j.epes.20190801.11

    Copy | Download

    AMA Style

    Amevi Acakpovi, Chiedozie Odazie, Issah Babatunde Majeed, George Eduful, Nana Yaw Asabere. Transformer Wireless Monitoring System Using Arduino/XBEE. Am J Electr Power Energy Syst. 2019;8(1):1-10. doi: 10.11648/j.epes.20190801.11

    Copy | Download

  • @article{10.11648/j.epes.20190801.11,
      author = {Amevi Acakpovi and Chiedozie Odazie and Issah Babatunde Majeed and George Eduful and Nana Yaw Asabere},
      title = {Transformer Wireless Monitoring System Using Arduino/XBEE},
      journal = {American Journal of Electrical Power and Energy Systems},
      volume = {8},
      number = {1},
      pages = {1-10},
      doi = {10.11648/j.epes.20190801.11},
      url = {https://doi.org/10.11648/j.epes.20190801.11},
      eprint = {https://download.sciencepg.com/pdf/10.11648.j.epes.20190801.11},
      abstract = {Distribution transformers are generally provided with advanced control measures that ensure their operation and safety at a high reliability because their failure usually leads to long power outage, increase maintenance cost and unreliable provision of electricity to customers. Despite the protection measures that accompany a distribution transformer, there is still a need to provide extra remote monitoring systems to increase the reliability of operation and the confidence of instantaneous fault reporting. This paper deals with the design and construction of automatic monitoring system for power transformer parameters. An Arduino board coupled with XBEE module were programmed to enable the monitoring of voltage, current and temperature on a typical power transformer. The system was implemented and tested successfully. Results showed that the voltage versus temperature as well as current versus voltage characteristic obtained, were closed to datasheet specifications and therefore confirming the reliability of the proposed design. This system is therefore recommended as an additional protection that should be added to Power Transformers.},
     year = {2019}
    }
    

    Copy | Download

  • TY  - JOUR
    T1  - Transformer Wireless Monitoring System Using Arduino/XBEE
    AU  - Amevi Acakpovi
    AU  - Chiedozie Odazie
    AU  - Issah Babatunde Majeed
    AU  - George Eduful
    AU  - Nana Yaw Asabere
    Y1  - 2019/01/31
    PY  - 2019
    N1  - https://doi.org/10.11648/j.epes.20190801.11
    DO  - 10.11648/j.epes.20190801.11
    T2  - American Journal of Electrical Power and Energy Systems
    JF  - American Journal of Electrical Power and Energy Systems
    JO  - American Journal of Electrical Power and Energy Systems
    SP  - 1
    EP  - 10
    PB  - Science Publishing Group
    SN  - 2326-9200
    UR  - https://doi.org/10.11648/j.epes.20190801.11
    AB  - Distribution transformers are generally provided with advanced control measures that ensure their operation and safety at a high reliability because their failure usually leads to long power outage, increase maintenance cost and unreliable provision of electricity to customers. Despite the protection measures that accompany a distribution transformer, there is still a need to provide extra remote monitoring systems to increase the reliability of operation and the confidence of instantaneous fault reporting. This paper deals with the design and construction of automatic monitoring system for power transformer parameters. An Arduino board coupled with XBEE module were programmed to enable the monitoring of voltage, current and temperature on a typical power transformer. The system was implemented and tested successfully. Results showed that the voltage versus temperature as well as current versus voltage characteristic obtained, were closed to datasheet specifications and therefore confirming the reliability of the proposed design. This system is therefore recommended as an additional protection that should be added to Power Transformers.
    VL  - 8
    IS  - 1
    ER  - 

    Copy | Download

  • Sections