International Journal of Industrial and Manufacturing Systems Engineering

Volume 2, Issue 6, November 2017

  • Development of Methodology for Main Pipelines Linear Section Stress-Strain State Сhanges Assessment

    Liubomyr Zhovtulia, Andriy Oliynyk, Andriy Yavorskyi, Maksym Karpash, Iryna Vashchyshak

    Issue: Volume 2, Issue 6, November 2017
    Pages: 66-71
    Received: 29 August 2017
    Accepted: 26 September 2017
    Published: 1 December 2017
    Downloads:
    Views:
    Abstract: The linear section of main oil and gas pipelines, which are potentially the most dangerous type of pipeline networks, was selected as the object of investigation. A technique for assessing the stress-strain state of the pipeline was developed. Underground pipeline deformation process was mathematically modeled according to the set of points displac... Show More
  • Improvement of Lubrication and Cooling in Grinding by Effective Controlling of Air Boundary

    Sujit Majumdar, Suraj Kumar, Debasish Roy, Samik Chakraborty

    Issue: Volume 2, Issue 6, November 2017
    Pages: 72-81
    Received: 5 September 2017
    Accepted: 26 December 2017
    Published: 16 January 2018
    Downloads:
    Views:
    Abstract: The presence of air around a rotating grinding wheel impedes the effective entry of coolant into grinding zone. Therefore, a proficient method is required to minimize this air boundary before the impingement of fluid-jet into the grinding zone. This paper is an experimental study for finding the better effective method of controlling the air bounda... Show More
  • Finite Element Simulation of Deep Drawing of Aluminium Alloy Sheets

    Shaik Himam Saheb, M. Sree Hari, Annam Vijay Kumar

    Issue: Volume 2, Issue 6, November 2017
    Pages: 83-102
    Received: 5 October 2017
    Accepted: 1 November 2017
    Published: 16 January 2018
    Downloads:
    Views:
    Abstract: More and more automobile companies are going for weight reduction of their vehicles for fuel economy and pollution control. The objective of the present study is to determine the effect of blank temperature on forming behaviour of sheets and damage factor of aluminium sheet alloys of 6061 and 7075 at elevated temperatures. Although the aluminium al... Show More